atg

3691087541?profile=original3691087736?profile=original3691087694?profile=original701869853_o.jpg701869833_o.jpg

Hi Guys

I am totally new to Quadcopters. Have been looking at frames and have found one I really like which is ATG  T2-X4-12 680 MM DUAL ARM. I have attached picture.

I wish to use APM 2.5 Mega control board.

I would like any suggestions for motors and esc,s. I have 3 sell batteries already and 10 ins carbon fiber props.

Any advice would be greatfully received.

Cheers,

Jeff.

701869833_o.jpg

701869853_o.jpg

701869825_o.jpg

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • I have this frame. 10" props won't cut it. It's been very good for me!

    I used a 6S 4K mAh battery, 40A hobbywing ESCs, HengLi 370Kv motors, and 15x5.5" carbon fiber props. Carries a 3 axis gimbal and gopro Hero 2 and all at less than half throttle. I am using an APM 2.6 running ArduCopter 3.2 at the moment. Max thrust with these specs was 22 lbs i believe.

  • Hey Jeff,

    Did you end up getting this frame?  If so, what do you think of it? I also like this frame, just worried about quality and overall fit and finish...

This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile
Jun 30
Santiago Perez liked Santiago Perez's profile
Jun 21
More…