Discussions

Connecting brushless gimbal to APM 2.6 without controller ?

Posted by Omer Ahmed on May 25, 2014 at 10:50pm

I have a brushless gimbal and BGC 3.0 MOS controller . I have burnt out my gimbal controller, so can i connect brushless gimbal servos directly to APM ?

Any suitable advise would be appreciated

You need to be a member of diydrones to add comments!

Join diydrones

26, apm, brushless, controller, gimbal

Email me when people reply –

Replies

James Overington May 25, 2014 at 11:57pm

Sorry, the brushless motors in your gimbal require relatively high power 3 phase input to drive them. Even though most brushless gimbal motors are connected with servo cable, the signals are completely different. We normally use an ESC to drive brushless motors but unfortunately these are not suited to low speed operation. I would not recommend plugging one of these motors directly into the APM outputs.
- Omer Ahmed > James Overington May 26, 2014 at 3:04am
  
  Thanks James for the clarification

This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile

Santiago Perez liked Santiago Perez's profile

More…

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.