Hello everyone.
I bought this gps to ride him on a plate of ArduPilot 2.5. The problem I have is that the cable is not worth that brings me to connect to the WAP 2.5 plate. I would like to ask if there is a cable for this gps, which can be connected to the board.
The gps has 4 pins and the plate has two entrances, one 5-pin and one 6 pin.
I hope your help since I have not much idea on this and forgive my writing because I do not control much the English language.
Thanks, I leave a picture of what I have.
Greetings.
You need to be a member of diydrones to add comments!
Replies
Hello.
Thanks for the help rendered.
regards
See also GPS-configuration info here: http://diydrones.com/xn/detail/705844:Comment:1222612
--ET
Hello.
Thanks again, very friendly.
I know more or less how it works now.
Greetings.
Hi all again.
No one can help me or advise me the method to connect the u-Blox GPS CN-06 GPS Receiver V2.0
APM to plate 2.5. It's more I search and read, I can not be sure.
Thanks and sorry for the inconvenience.
I believe this cable fits the 6-pin GPS port on the APM:
FTDI GPS Adapter cable 15 cm $1.75
http://store.3drobotics.com/products/ftdi-gps-adapter-cable-15-cm
--ET