Drone cannot take off, strange sound appears

Dear all,

Today, I upload a stable version of PX4 firmware (ArduCopter-v2.px4 2016-02-24 14:27 643k) from http://firmware.ardupilot.org/Copter/latest/PX4-quad/

When I try to take off the Drone, 1 strange sound appears and drone ignores the 'take-off' command

I upload this sound on Youtube: 

https://www.youtube.com/watch?v=a5gMB0S6tCc

Dose anyone know about this problem? Please support me to fix it

Thank you very much

Anh

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • Thank you Joe,

    You are right, this sound is exactly about energy problem. In my case, I make a mistake when doing calibration

    I should choose "NONE" option, instead of Px4 power module (I used a different type) like the attached photo

    3702300754?profile=original

    My problem is fixed, once again, thank you very much

    Regards,

    Anh 

    Capture.JPG

  • Sounds like low voltage alarm, look here

    Did you go through set up per manual at this page ?

    Sound warnings at here

    Joe

    Power Module Configuration in Mission Planner — Copter documentation
This reply was deleted.

Activity

DIY Robocars via Twitter
RT @donkey_car: Human-scale Donkey Car! Hope this makes it to a @diyrobocars race https://www.youtube.com/watch?v=ZMaf031U8jg
Jun 25
DIY Robocars via Twitter
Jun 25
DIY Robocars via Twitter
Jun 16
DIY Robocars via Twitter
RT @GrantEMoe: I won my first @diyrobocars @donkey_car virtual race! Many thanks to @chr1sa @EllerbachMaxime @tawnkramer and everyone who m…
Jun 13
DIY Robocars via Twitter
RT @gclue_akira: JetRacerで自動走行したコースを、InstantNeRFで再構築。データセットは別々に収集 #jetracer #instantNeRT https://t.co/T8zjg3MFyO
Jun 13
DIY Robocars via Twitter
RT @SmallpixelCar: SPC 3.0 Now the motor also works. This car is doable. I just need to design a deck to mount my compute and sensors. http…
Jun 13
DIY Robocars via Twitter
RT @SmallpixelCar: My new car SPC 3.0. https://t.co/CKtkZOxeNQ
Jun 7
DIY Robocars via Twitter
RT @SmallpixelCar: High speed at @diyrobocars thanks @EdwardM26321707 for sharing the video https://t.co/o4317Y2U1S
Jun 7
DIY Robocars via Twitter
RT @SmallpixelCar: Today at @RAMS_RC_Club for @diyrobocars. Used @emlid RTK GPS and @adafruit @BoschGlobal IMU. Lap time 28s https://t.co/R…
May 28
DIY Robocars via Twitter
May 15
DIY Robocars via Twitter
May 14
DIY Robocars via Twitter
May 13
DIY Robocars via Twitter
RT @f1tenth: Say hi to our newest #F1TENTH creation for @ieee_ras_icra next week in Philly. It’s going to be huge! 😎 🔥 @AutowareFdn @PennEn…
May 13
DIY Robocars via Twitter
May 11
DIY Robocars via Twitter
May 8
DIY Robocars via Twitter
RT @SmallpixelCar: Noticed my car zigzagged in last run. It turned out to be the grass stuck in the wheel and made the odometry less accura…
May 8
More…