HI all I have built a simple x525 configuration currently have a kk boards v5.5 on board...

I have just received my ardupilot 2.6 with ex gps compass. i have managed to upload firmware for quadcopter from AP> software via usb....I need to go into initial setup......but it appears i can only setup firmware to unit via built in micro usb.

I guess I overlooked to order another interface to allow me to set up the drone..

any help welcome from this point would be welcome......

At this stage i would be happy to just use the arducopter as flight control board and then look at setting up missions after this.

Note I Use osx (Mac)  If anyone has done a similar build blog with set by step set up i would appreciate a link......

also what usb adapter do i need to set up...? 

I have taranis tx with x8r receiver.....

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • Oh well simple mistake unplugged the usb programming lead and the usb option re appeared on the drop down menu.

    Happy setting up the system now.

    Just need a few thoughts on mounting the gps/compass module on the x525 frame

This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile
Jun 30
Santiago Perez liked Santiago Perez's profile
Jun 21
More…