Discussions

Mavlink stuck

Posted by mrBert on February 10, 2014 at 10:03am

Hi All,

I have problem after updated Mission Planner to new version according to massage box that shown when I run the Mission Planner. I got stuck at "Got param RC10_MAX", the error massages are show below.

Please help me on this :)

Thank you very much.

You need to be a member of diydrones to add comments!

Join diydrones

got, mavlink, rc10_max, at, error, param, stuck

Email me when people reply –

Replies

joshua Chastain March 2, 2014 at 5:52pm

hav you had any resolve with this. I too, am just now getting this error? im not sure whats wrong.. maybe we can help each other.
- mrBert > joshua Chastain March 2, 2014 at 6:33pm
  
  Yes,Joshua. I have changed 3.3v ic regulator, right now it fine. Please see more detail at http://diydrones.com/forum/topics/apm-2-5-no-dataflash-compass-init...
  
  You can start reading from the begining :)
  - Hafidz M. > mrBert April 17, 2014 at 9:12pm
    
    I have the same problem like you posted above, except that the Got param stuck at RC10_TRIM.
    
    I have checked voltage at I2C socket and found the voltage is 3.28 V so the problem is not with the voltage regulator.
    
    If that's not the problem, what could be the possible problems??
mrBert February 10, 2014 at 10:05am