Is there a way or is possible to be added on the mission planner to set this?

 

# define INPUT_VOLTAGE   X.XX


So that correct voltage will show on ArduStation/Mission Planner without uploading via Arduino IDE. V39 is not yet on download section so I can only upload via MP.


Thanks

Views: 110

Reply to This

Replies to This Discussion

Michael, any chance or plan this can be added too? I know it needs an equivalent PARAM that can be loaded via MAVLink if not then no choice but to stick with Arduino IDE for now.

Reply to Discussion

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service