Hi
This is killing me seriously
Trying to figure it out for 3 days
this is for a hex so running 3.2.1 is the plan
If I load firmware plane copter whatever and set the cam trig parameters, I can trigger the camera no problem as long as I don't depower the pixhawk
As soon as I depower and restart there is no triggering at all, I have to reload a different type firmware ie if I was on copter I have to load plane then set params it works, depower repower no worky.
if in copter 3.2.1 going to copter 3.2 wont work have to go plane rover whatever to reset
Am I missing something
Checked the on board battery it reads 3.15v
Tried swapping sd card no difference
Im at a complete loss atm I have to keep the thing powered to keep working or reload firmware and params every flight
when loading firmware it says px4v2 briefly while loading
had trigger working great on apm 2.5 thought id upgrade but so far just a headache, although it did fly nice when I test flied it
heres a link to the set I bought
please any thoughts help greatly appreciated
Replies
starting to think its a hardware issue
worked for about 4-5 restarts with relay_pin mapped to aux5 but ir trigger was plugged into aux 2. weird.
why would it work after resetting firmware then not. aaaarrrggghh