since i don't have a current/volt sensor yet. i wanna know what will be the value of the resistor of the voltage divider for the A1 port of the APM 2.5
tnx!
You need to be a member of diydrones to add comments!
This reply was deleted.
since i don't have a current/volt sensor yet. i wanna know what will be the value of the resistor of the voltage divider for the A1 port of the APM 2.5
tnx!
You need to be a member of diydrones to add comments!
Replies
judging from the schematic of the volt/curr board offered by Sparkfun, I'm going to use a strinv of 10k+4.7k+4.7k, connecting the last 4.7k to A1 line, with a .1uF cap across it. See schematic on Sparkfun
bo