You need to be a member of diydrones to add comments!
This reply was deleted.
Activity
RT @gclue_akira: 柏の葉で走行させてるjetracerの中身 #instantNeRF #jetracer https://t.co/giVvuE4hP7
Cool web-based self-driving simulator. Click save when the AI does the right thing
https://github.com/pncsoares/self-driving-car
RT @donkey_car: Human-scale Donkey Car! Hope this makes it to a @diyrobocars race https://www.youtube.com/watch?v=ZMaf031U8jg
RT @GrantEMoe: I won my first @diyrobocars @donkey_car virtual race! Many thanks to @chr1sa @EllerbachMaxime @tawnkramer and everyone who m…
RT @gclue_akira: JetRacerで自動走行したコースを、InstantNeRFで再構築。データセットは別々に収集 #jetracer #instantNeRT https://t.co/T8zjg3MFyO
RT @SmallpixelCar: SPC 3.0 Now the motor also works. This car is doable. I just need to design a deck to mount my compute and sensors. http…
RT @SmallpixelCar: High speed at @diyrobocars thanks @EdwardM26321707 for sharing the video https://t.co/o4317Y2U1S
RT @SmallpixelCar: Today at @RAMS_RC_Club for @diyrobocars. Used @emlid RTK GPS and @adafruit @BoschGlobal IMU. Lap time 28s https://t.co/R…
RT @f1tenth: Say hi to our newest #F1TENTH creation for @ieee_ras_icra next week in Philly. It’s going to be huge! 😎 🔥 @AutowareFdn @PennEn…
Replies
Yes me too with the same modules.
Still working on the problem here, but it would be good if the OP could elaborate on what he meant by airspeed too low.
I'm not sure if he meant the V2 had an airspeed set below 64k or if he changed ALL his radios up to a higher airspeed data rate to get all working ?
What's too low?
My airspeed is set at 64, the default, and sure enough I can't get my rfd900 to sync with that v2 radio
Please, where can i find a detail guide in order to setup my RFD900 to V2. Actually, I have couple if RFD900 working together, but i am building a new UAV so i am thinking to use the RFD900 as ground station and V2 in air, for this units. But remain my current sepup for my old UAV. How much range do you get with your RFD900 to V2 configuration?...