Hello guys
I install my pixhawk in Skywalker X5, when I tested the servos and throttle, throttle work well but the servo didn't work.I use Red Brick 50 Amp for my ESC, Futaba T8J, and 5300 mAh 11,1 V for my battery.
Any advice ?
You need to be a member of diydrones to add comments!
Replies
Ferdie Misnadi What servos are you using? Some of my planes using Hitec HS65HB carbon gears and some using Turnigy MG90S metal gears. These two servos operating current are 4.8 - 6 volts and works very well with Pixhawk. I have no issues so far except for if the planes had crashed then the servos need to be checked.
Did you brought power to the servo connectors ? For example by hooking a BEC on a free slot, or using the BEC from your ESC if it has one.
Im not using the bec for my ESC, I just upgrade the firmware from ardupilot 2.74 to ardupilot 3.01. But when I use 2.74 the servos are working but when I upgrade to 3.01 It didn't work but the throttle is working.