Hello, I have seen in the Wiki that APM2 has two inputs for current sensors, I wondered howto monitor. the Mission Planner. the two batteries, as it only shows one.

I have two batteries, one for motor. and one for servos, rx and APM2. and would like to have control over them.

Views: 326

Reply to This

Replies to This Discussion

Well, I'm sure there are more than one person with this same problem.

Another problem I'm sensing is that the Mission Planner I save settings when I select the current sensor 90A attopilot, always fits me like others.

Reply to Discussion



Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2018   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service