XBee delivers telemetry but not for long

Hi everybody,

I am having a hard time getting telemetry data onto the Mission Planner Software. I use the Ardupilot 2.5, two XBee Pro S2B, the Extreme Bee V12 adapter in the plane and an USB XBee adapter V10 on the ground. When I hid the connect button in the Mission Planner the connection starts as seen in JPG 2. I can see the horizon moving and I receive Data in that state, quit satisfying I thought first time. The tlog.file proves I wasn´t dreaming. But this lasts for around half a minute. Then an error occurs as seen in JPG 1. I don´t have a clou what might be wrong. Can anybody give advice?

Thanks from Bremen, Germany

2014-01-27 12-01-32.tlog

Fehlermeldung1.JPG

Fehlermeldung2.JPG

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • Hi,

        I am also trying to setup communication between UAV and GCS using Xbee-S2.  I am getting mavlink packets shown in JPG1 but after some its showing connection failed. According to me the transmission power of Xbee-S2 is not sufficient. I will try to do again using Xbee-S2.

    Any Suggestion?
     

    DSC_0586[1].jpg

This reply was deleted.

Activity