Discussions

Xbee doesn't work any more with new software

Posted by CyberCrash on May 7, 2011 at 4:07pm

Hey guys,

thanks for the great new software. I love all the functions there are and everything works great.

 

Except my xbee modules I used before with Ardupirates don't work any more with the new Software. I didn't change the settings and the BAUD rate is still 115200.

 

I just flashed the new software...that's all.

 

Any ideas?

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • michel pet May 9, 2011 at 8:58am

    i test the 2,4 xbee but noting works.

     the xbee is working ok with the 57600 speed i test it with the loop test.

     

    it looks like com 3 is not open in the software.

  • Russell B. Sutton May 7, 2011 at 5:44pm
    Ok now i guess its my turn I changed my xbee settings but the Tx/Rx lights on the IMU are not responding to any xbee signals.  I tried the xbee test in the CLI but even then the lights do not flicker on the IMU.  the xbee lights come on just not the IMU
  • CyberCrash May 7, 2011 at 4:37pm
    Thank you so much.

    I was so excited to flash the new firmware I totally overread this part.

    Thanks for the information.

    Best regards
    Kai
  • Russell B. Sutton May 7, 2011 at 4:31pm
    THe new software uses 57600 on the tele port  re-flash your xbee's to 57600.     
  • 3D Robotics
    Chris Anderson May 7, 2011 at 4:28pm
    On AC2 the Xbees run at 57k (like APM). Please see the manual.
This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile
Jun 30
Santiago Perez liked Santiago Perez's profile
Jun 21
More…