Posted by Richard Boyhan on September 29, 2013 at 6:50pm
Can't get my Y6 to work with my PX4. Had everything working with my APM. But when I tried to use my PX4, no prop spin. My PX4 has an IO board and it's taken a bit of time to get everything solder together an running. I've gotten the firmware to load and done all the basic calibrations yet when I try to spin up the props I get nothing. I've even try to calibrate the ESC's, I get the tones but no spin.Anyone have any suggestions of what I might try?Firmware is 3.0.1.
You need to be a member of diydrones to add comments!
Are you getting any warning messages back from the APM, as this seems like a PreArm check failure not allowing you to arm. Are you connecting using MP?
Replies
Are you getting any warning messages back from the APM, as this seems like a PreArm check failure not allowing you to arm. Are you connecting using MP?