New Problem- Dead Stick in all modes except Manual

Posted by Hayden Wilson on July 23, 2014 at 12:20am

Hey Everyone.

Thanks for the help with sorting out the elevon mixing so that the plane autocorrects in the correct direction.

I now have a new problem. When I am in Manual mode the plane responds to all inputs from my transmitter, However when I swap to another flight mode it only responds to the throttle input.

in other flight modes it still autocorrects as it should.

Any Ideas would be very appreciated!

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Hayden Wilson July 24, 2014 at 2:27am

    Okay. Problem solved. I had to reset everything to default and then recalibrate.

  • Hayden Wilson July 23, 2014 at 7:39am
    Yep done my radio calibration. When I swap from manual into FBWA, FBWB and stabilise all inputs from my transmitter except throttle stop working.
  • 3D Robotics
    Chris Anderson July 23, 2014 at 7:00am

    I assume you've done the regular RC calibration as part of the setup process? You're saying that in Stabilize it does't respond to the sticks at all?

    BTW, in all auto modes, you should be able "override" with manual input so you can nudge the aircraft on a mission if needed. 

    • Hayden Wilson > Chris Anderson July 23, 2014 at 11:00pm

      Hi Chris. I have done my radio calibrations and it just does not want to respond at all. I have tried re-installing the firmware but that has not worked either. Is there a hard reset that I could use to revert the board back to factory defaults?

This reply was deleted.