Place apm 2.5 on a plane

Posted by azerty09 on September 3, 2014 at 2:26am
HelloWould this be a useable place to glue it on my plane? (If I could do it like this, I do not need to 'destroy' (cut in) my plane...My plane is a hk reaktor epp, a 80(?) cm '3d' plane of hobbyking.Wouldn't all the possible problems be solved by the callibration?See pictures attached...Great thanks in advance :)

image.jpg

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • MR60
    Hugues September 3, 2014 at 10:36am

    I would suggest another plane because yours is absolutely not made for that. How would you intend to wire everything on such a small plane??

    • azerty09 > Hugues September 3, 2014 at 12:35pm
      I know my plane isn't made for this purpose, but like to do different, the wiring wouldn't be that difficult.
      I have flown a hk bonsai (60 cm! Wingspan) succesfully with the apm and gps.
      It will as long as it has enough power.
      I will post pictures over 1-2 weeks when it's ready (need new transmitter)
      Wish me luck!
      Great thanks :)
      G.P.S. Gestione Pubblicità Speciale
  • Simon Howroyd September 3, 2014 at 2:56am
    I would suggest using foam tape rather than glue. Less vibration and won't damage the model if you need to move it
    • azerty09 > Simon Howroyd September 3, 2014 at 3:03am
      Like this is ok?

      image.jpg

    • azerty09 > Simon Howroyd September 3, 2014 at 3:01am
      Ok thanks, so a do not need to cut into my fusselage? Just tape it on the side of the plane, like shown in the picture?
This reply was deleted.