throttle and elevons lowers when switching to stabilize, heeeeeeeelp!!!!!!!!!!!!!!!!!!!

Posted by azerty09 on September 8, 2013 at 3:15am

hello

when switching to stabilize, the throttle ( and also the elevons) lowers, the throttle lowers to half!!!!!

I can't find it in the parameter list:(

another serious plane: the steering output is much lower when switching to stabilize:(

can anyone please help with this, I haven't flown well with my plane since the apm came:(

thanks in advance!!

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Jeff Zika September 9, 2013 at 3:21am

    Had a similar problem. Ended up being a trim issue. Had to reset centers on the elevon servos and the control horns. Fixed the problem.

    As for throttle, your cruise throttle setting may be too low. Try turning on throttle pass-through.

  • zubair aslam September 8, 2013 at 10:45am

    In MP under configuration tab in Arduplane Pid change the MAX_Throttle parameter to around 80 %. Also change the bank angle to around 40.

    Well i recommend you to spend some time in reading the manual.

This reply was deleted.