Hi folks !

yesterday, i was testing my hardware for a flight this weekend.

But when i tried the telemetry, i saw the data on my computer with a lot of lag.

I tried this :

With X-CTU :

Unbrick the Xbee in W7 64 bits --> don't work

Unbrick in W7 32 bits --> Firmware 1061 @ 115600 -->OK

Vid, Baudrate & DD are the same.

My APM is plugged with ESC and ESC + USB

--> Change speed in config of ArduPlane2.24+Remzibi+Status_Leds.rar  to 115600 bts for port 3

--> Can connect my APM to the Mission Planer but data are very slow to refresh.

--> In console mode i saw the data corrupted ( ex : Calibrating Gyro ??,)) ??,azd))°?,.... calibrating.... )

-->  Last week, the telemetry was ok @115600 with the port shared with Remzibi.

Should i flash my Xbee again or did i forget something ?


Thanks a lot

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • Same thing happened to me, but it wasn't until I was outside in the park that it started to slow. Same Xbee 900. What would cause this?

This reply was deleted.