My FPV set up is a 500mW 2.4Ghz system, and I cant get the VTx to establish a connection to my Vrx. I always get the "No Signal" + static on my Hobbyking DIY FPV V2's. Before I start the description, below is a list of the equipment I'm using. Pictures of my wiring, and a drawn schematic of the wiring, are available at this link -- https://www.dropbox.com/sh/nvbzmtin03su0la/AAChK-4JrgbJiDqvlfYsPstja?dl=0
Flight Controller: HKPilot 32 (Beautiful Hobbyking Pixhawk Clone)
Video Transmitter: TBS Unify 2G4 500mW
Video Receiver: Lawmate RX-2460
OSD: Micro OSD (Smaller MinimOSD derivative designed to perfectly fit Pixhawk & APM)
I'm pretty confident my wiring is fine, because everything seems to be getting power with all the correct LED lights lighting up. I know the camera is on because it get a bit warm too. The problem begins when I switch both my FPV systems on. I've tried all channels 1 through to 8 by adjusting the DIP switches on the RX & TX accordingly, but I still always get "No Signal".
I've even tried connecting the vtx straight to the camera and BEC, without the OSD in the middle, and I still didn't manage to get a signal. Hence ruling out the possibility of the OSD being the problem.
I did notice however that when I got the Antennas of the VTX and VRX very close, the constantly appearing and disappearing horizontal black lines in the screen static would disappear. They would then slowly re-appear as I brought the antennas further away from each other again.
I am currently set on the Channel 1, 2410 Ghz band on my Vtx and Vrx.
I've spent a lot of time, effort, and money on this, so any help on getting this work would be massively appreciated :):D