unable to connect MISSION PLANNER

Posted by hamidreza ebrahimi on January 9, 2014 at 5:01am

Hi, I'm programming over APM 2.6 firmware version 3.2, I'm now unable to connect MISSION PLANNER 1.2.92, then select the type of installation Quad copter firmware tab and download the hex file I get the error message encountered NO connection. Please help to resolve this problem. APM firmware if I want to return to the ARDUCopter 3.1 What steps should do. Thank

3691089408?profile=original3691089369?profile=original3691089324?profile=original

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Josef Míka January 9, 2014 at 10:11am
    I dont know solution, but i have same problem on my notebook. I think that is too many com ports problem. I have big numbers of com ports too. When i used netbook of my childrens everything was OK.
    So when i need upload new firmware take childrens netbook. Try other pc . Not good solution but efective:-)

    Josef
  • Admin
    Thomas J Coyle III January 9, 2014 at 5:48am

    @hamidreza,

    I think that you may be having a Com port problem. Your Com port number jumped from 2 in the second picture to 24 in the third picture.

    Also, you might be having this problem if you have Bluetooth enabled.

    Regards,

    TCIII ArduRover2 Developer

This reply was deleted.