iRise + - Mission planner doesn't show COM ports OR USB ports.. - IRIS

Michael Burmeister December 16, 2014 at 9:46am

Ok, I built a windows 8 system and the drivers do not load without turning driver signing off. Option 7 on the restart windows menu under advanced options.

You will also need to uninstall Mission Planner and reinstall to get the drivers to install correctly. Then everything should work.

Drivers are signed by Michael but windows does not trust him.....

Michael Burmeister December 8, 2014 at 7:12pm

What operating system are you using. The port sometimes does not show up for a while.

The error message you showed is for Mission Planner trying to download the Firmware from the internet site. You most open a port on your firewall to allow Mission Planner access or stop your virus software when loading firmware.

Taj Haslani > Michael Burmeister December 9, 2014 at 6:47am

Windows 8.x 64 bit with avast antivirus (free version)
Roberto Andrade > Taj Haslani December 14, 2014 at 6:49pm
I have windows 8.1 with norton antivirus

when I turn off the firewall the MS display the same message

the problem is that it does not recognize the COM port.

Roberto Andrade December 8, 2014 at 6:33pm

Hello , I have the same problem and the software displays this this message:

thanks for any comments.

Taj Haslani > Roberto Andrade December 9, 2014 at 6:46am

I see same message. Thanks

3D Robotics

Vu Tran December 8, 2014 at 4:04pm

Hi Taj,

If it's just firmware that you want to flash on the vehicle, you can find the directions at the 2:50 mark. Instead of plugging the USB into the Pixhawk, you can plug the USB into the USB port on the IRIS+ and proceed the same way.

https://www.youtube.com/watch?v=RZQFmd8MBZI&feature=youtu.be

But here's a video on how to connect to Mission Planner as well: *the caveat is that you will need to set the BAUD rate to 115200 instead of 57500 like it says in the video.

https://www.youtube.com/watch?v=IodRqijn1Aw&list=UUcp-_sF8s4WIZ...

Let us know if you have any more questions! You can also call us at (858) 225-1414 for support!

YouTube

Roberto Andrade > Vu Tran December 14, 2014 at 6:52pm

Hi Vu,

I have windows 8.1 with norton antivirus

when I turn off the firewall the MS display the same message

the problem is that it does not recognize the COM port.
Taj Haslani > Vu Tran December 8, 2014 at 4:24pm

Thanks for the reply.

My issue is that I don't see COM or USB option on Mission Planner software.

I see only Auto, TCP & UDP. I tried auto but didn't connect.

I also tried re-installing MP.

IRIS

Replies