Hello guys, I received my Pixhawk. But have a problem with instaling of firmware(Adruplane 3.2.3) using Mission Planner(1.3.19)
I have the PixHawk connected via the USB cable. It seems to work. Follow all instruction, but all times , I dont hear any
I need to short 2 pins on an camera to trigger it. Is there a way to do this directly from a pixhawk? Or perhaps I have to make an external relay circuit driven by the pixhawk? I have tried several RC switches with no luck.
Read more…I would like to waterproof my pixhawk as much as possible. Last summer I installed one inside a frame called an Aqucopter which did well for waterproofing but suffered badly from the baro being so isolated form the outside alt hold was really bad. I
Read more…I've asked the question several times in various forums. Nobody has yet answered the question.
The most complete answer was from Randy, but did not define how INAVerr is calculated and why 255 is bad, only that it may be a problem in my logs.
It has to
Read more…I'm building a Tarot-680Pro with 3DR Pixhawk and I will be using a Fatuba T8FG Radio, And I'm going to be setting up S-Bus, will the FrSky X8R Receiver work with the T8FG Radio without anymore hardware, connected to PixHawk ?
Read more…Hi,Read more…
I am new to pixhawks and right now, I will say I got a clone! I know, I know....
But I am on a budget so here I am...
Anyway, I connected it to my computer for the first time and pressed the connect button (top right) no
problem, if I move the unit
2 questions: what is the "Circle" mode? The other question is does any one have a Taranis Eeprom for a hexacopter that I could use as a standard to program the radio?
Read more…Is the Pixhawk at this loacation a Good or Bad Buy ?
Read more…Bench testing my PixHawk and trying to get all systems working ...going fine untill I connected up the APM MinimOSD. No Video or OSD. I know the video setup is working because when I pull hte MinimOSD out of the connection I have very good video.
Read more…
In this article, KDE is recommending what looks to be powering OPTO ESC systems from the PM both to the power connector on top of the Pixhawk, and also connecting to the power rail on the back.
http://www.multirotorforums.com/showthread.php?22043-KDE-
Read more…I have used APM until now to outfit all my copters ( Quads) until recently feeling the push to move to the PixHawk. I have had a few builds go perfectly fine until this morning. I have gone over everything as best I know how to no avail.
The copter a
Read more…1) Does the Pixhawk need to be at the CG of the copter (a la Naza)?
2) Does the GPS need to located in front of or behind the FC or can it off to the side as long as it is pointing in the same direction?
Read more…Hi
So Im at the point where I have my K130 octo ready and setup my Taranis flight modes etc.
Simple tests at home comfirm the engines are starting and it wants to take off.
(It needs very little throttle since it has good power and not loaded yet.)
So lo
Read more…Hi guys! I not pro or against clones but I saw this today on GoodLuckBuy:
It appears to be a revised version with this description:
Read more…Please note moving forward all support will be handled here.
http://ardupilot.com/forum/viewforum.php?f=21
Read more…
