All Discussions (258)

Sort by

Stop gimbal control

So, back before I installed a gimbal on my quad, I strapped a mobius camera to the front and all worked well with ROI missions using Mission planner. Setting ROI points caused the craft to yaw towards the ROI point as expected.

Now, as I have a gimbal

Read more…
0 Replies

Pixhawk capability

Hello

I want to use pixhawk for my octacopter, with about 30 KG take of weight but I am not sure that it could be suitabe and safe or not.

would you please help that it is a good choice or I should change my decision?

Thanks

Read more…
4 Replies

Pixhawk capability

Hello

I want to use pixhawk for my octacopter, with about 30 KG take of weight but I am not sure that it could be suitabe and safe or not.

would you please help that it is a good choice or I should change my decision?

Thanks

Read more…
1 Reply

Turnigy Trust 70A Issues

Hello all,

I have been working on a VTOL modification for a couple of weeks now, and had just gotten to the point of conducting a few hover tests. The night before I went through and checked to make sure everything was properly functioning, and all wa

Read more…
9 Replies

Bad Compass Health

I'm having a problem with a Pixhawk that came with a 3DR DIY 4X kit. APM Planner is reporting "Bad Compass Health". The compass is an external uBlox GPS combo that came with the kit.

I've tried several solutions that include,

-running APM Planner with

Read more…
23 Replies

px4 and camera trigger

hi folks, 

need some help pls, i am totally frustrated, because i am not able to get the trigger function from px4 working.

my envirement :

original 3dr px 4 - current firmware 
camera sony nex 7
shutter gentLED-shutterPLUS ( 039 ) for sony nex 7
shutter o

Read more…
0 Replies

back up power

Hello everybody,

I was wondering if it is possible to configure servo rail for back up power, I have read this sentence on this wiki page and the real matter is that I can't really figure out how can I configure this feature.

To be honest the word conf

Read more…
2 Replies

Intelligent follow algorithm

Hi All,

I need to implement a follow algorithm so that the UAV follows a test car using the GPS data it receives through the Car-to-X module. The goal is to follow the car and produce good quality video recording of the car and it's surroundings. I am

Read more…
4 Replies

Facing problems while calibration

I am currently building a H drone as my college project but while calibrating my pixhawk from mission planner , i am unable to calibrate my transmitter as no green bars are appearing on calibration page. And I am unable to calibrate the accelerometer

Read more…
1 Reply