Group for discussion on Walkera copters using the modified version of the ArduCopter software.

14 Members
Join Us!

You need to be a member of diydrones to add comments!

Join diydrones

Comments are closed.

Comments

  • I do think the Gimbals big brother that supports the Sony RX 100 111 could be a great combination. Anyone tried that yet?

  • I was toying with the idea to get a H500 but decided not to do that due to the total lack of communication from the factory. The don't even reply to questions regarding sales.......

    I did buy a I-Look camera with 3 axis gimbal and I would say that the gimbal works very well. The camera is not quite as good as the GoPro 3+ and I changed the lens for a Rage 5.4 and it was then very good but like the GoPro the user must limit the use of any pan movements due to the low screen/data refresh rate with these small cameras.Used correctly it is capable of some very sharp and steady footage with good colour saturation. 

  • Developer

    @armahdi,

    It's a bit hard to understand what you're asking and no need for the all caps.

  • U CAN SEND TOTURIAL DEVO 10 TELEMETRY USE FULLL AND PART TO BUYING

  • WALKERA X350 GPS ,,, CANT USE ALL ZONE GPS

  • WHT IS THIS ,, WALKERA ,, WHY WALKERA NO FUCTION GPS NORMAL IN ALL ZONE

  • I am presently flying a QR X350 Pro with some changes. I have put on the extended legs, but find that they quad wont stop and lock on landing. I have to bring it down, go into hover, reducing throttle and as it gets down to ground level, quickly flick the hover switch off and the throttle off at the same time.

    I am also working on installing folding u/c, using and modifying the folding undercarriage listed on hobbyking. I have installed the modified unit and it works. I have some electronic problems at the moment so the quad is not in the air but the legs work and is not related the the present issue. The quad wont unlock, have new receiver, tested the flight controller, both work fine, am going to replace the power board as this is the only thing left unless there is an Esc problem although when binding all motors kick.

This reply was deleted.

Walkera Gimbals

Hi Guys anyone else playing with these gimbals. My first impression is that they are quite an advanced design, along the same lines as DJI in that they use a clutch drive with position encoded motors. Getting any response out of Walkera through their website is like talking to the wall. So I guess we will need to work though various agents if we want any info. 

Read more…
0 Replies