Hi I am facing problem in position hold mode for X7 flight controller, stabilized and altitude hold mode works fine as soon as I switch to position hold the quad is unstable any suggestions
I have autotune roll axis and same parameter for pitch axis
ArduPlane 3.1.1 not working proper on flying wing any body else facing problem as soon as switch on to fbwb or auto mode it nose dive and roll on one side.
I want to do auto take off from kite wing but problem is when i give throttle at take off i have to hold down elevator to maintain climb angle other wise it will stall or loop at take off how to handle this in APM.
Today i crashed when testing the APM when my plane took a left turn 180degree waypoint in tail wind it went into left spin and could not recover. what i think is the torque of motor and large 20.5x14 prop caused can any one tell dose AMP cater for to
Hi,Any one tried to install ardupilot mega in T580. I opened T580 it has one speed controller which controls all 4 motors and it has i suppose 2 differential inputs coming from its controller board can APM handle this or have to put 4 speed controlle
Hi,I am wondering if mission planer could use scan map as internet is not available at all the places or there is any way to use goggle earth without live net?Ahmed
This is the spec of my new electric UAV.All developed in house including the autopilot.1. Wing Span 9ft2. Brushless motor3. Gps Autopilot control4. Mini camera with video TX5. Radio Modem6. 5-10km radius operationAutopilotHas gps navigation with prog