Hello friends.
I'm trying to make my maja landing on parachute in a more perfect way (not like now). At the moment i use a mission like this:
So, the land waypoint and the waypoint where the chute should be opened are located close to each other to mak
Read more…Hello.
I have MinimOSD v1.1 and it works fine when APM telemetry is configured for 57600. But my XBEEs work on 9600 only. So if there is a possibility to change OSD's serial baudrate to work on 9600 ?
Where can i get the firmware source and which param
Read more…Hello everyone !
I have an APM 1 with ArduPlane V2.28 firmware.
I'm trying to use "DO_SET_SERVO" command to open the chute.
To test its action at the table before using it in flight i connect a servo to the 5th channel and make 4 commands in APM planne
Read more…Hello, friends!
I have a question about the ability to use APM Planner coupled with ArduStation for antenna tracking. Actually i want to try the new 3DR radios instead of XBEEs.
I tried different settings in "Antenna Tracker" options section in the APM
Read more…Hello friends!
I'm a very new to the diydrones community so please don't beat hard )
I've got:
1) ArduPilotMega1
2) 2 x XBee Pro 900 XSC modules:
- http://www.sparkfun.com/products/9085
- http://www.sparkfun.com/products/9087
3) XBee Explorer Regulat
