LightWare SF10/x via I2C?
Help!!
Tried to connect as in the wiki, but no readings?
Do I have to change the I2C adress on the SF10/x, default 0x55?
Running APM:Copter V3.3.1.
Is it possible to see devices connected to the I2C bus?
Read more…Alf Pettersson's Discussions (3)
Sort by
LidarLite v2 on altitude > 15 m
I have a LidarLite v2 that I use with Arducopter 3.3.1. Everything is fine as long as I fly below 15-20m but above that I only get correct altitude every now and then?
It is connected to the I2C port with 700uF on +/- cabel powered from a separate UB
Lidar Lite and Copter V3.3
I have problems with my LL (LidarLite) after take off I get a message from MP (MissionPlanner) "Bad Lidar Health" and then I get readings from LL every now and then?
I Think I have installed Everything as in the manual.
