I am having an issue that is strange , the only I get the 5v power on the VDD_5V_PERIPH line is when it is connected to usb cable and pc. If I connect the power cable all the lights on the we will light up . If I power feed it by the power te
Read more…I was reading some info Chris posted about BBB being worked on as a autopilot. In the discussion was mentioned a Pixhawk Fire Cape. Where can I find the Pixhawk Fire Cape. I have been following the build on Beaglepilot site but not finding a lot of i
Read more…A while back I purchased one od the DJI F330 kits with esc's and motors. I had a NAZA control unit so I used it to play around with. When I would fly the quad I would notice when taking off the right front was always lazy about coming up. It says you
Read more…I was setting up ch6 on my 2.5 and accidently plugged my Receiver channel 6 output into the APM 2.5's output 6. Now I can't connect MP to the APM. I no longer get all the flashing lights. I can hit the reset and get some instant flash but no connecti
Read more…Quick question guys, I have a 3DR version 1 air telm. module that has 4 wires. I need to find out what the terminals are on the 2.5APM. It looks like the inboard pin is VCC and I assume the outboard pin is ground. I am not having any luck at what the
Read more…Hello, I am new to ArduCopter world. I Just purchased the Ardupilot 2.5, it arrived yesterday. When I connect it to my computer I can not get it to connect. I can go into the terminal and it will connect and give alot of info on the screen. Can someo
Read more…