Gender
Male
About
Location
Ongole
About Me:
I'm from Ongole,AP, India and I'm postgraduate in Electronics and Physics. I'm really interested in UAVs and drones.
Please tell us a bit about your UAV interest
I'm interested in drones and Unamanned and Autonomous Vehicles.
Hometown:
Ongole
Activity Feed
"With my experience and research if you are going build using locally available Aluminium frames then for the specs you mentions you should go with either 3/4" or 1 inch SQUARE al pipes (instead of round ones). Its easy to drill and fix the…"
"Hi, The Quadframe weighed around ~290 gms and ~970 gms with everything fixed."
"The Quadframe weighed around ~290 gms and ~970 gms with everything fixed."
"Hi Mr. Mathew, thanks for the suggestion. I have KK Blue board with v1.5 and Tx is Futaba T6EXA 6 channel with expo. Could you please elaborate the procedure to achieve the stable hover. Thanks"
Hi thanks for dropping the line. Well I have one more doubt. Can I make 10x4.7 prop to 8x4.7 prop by measuring and cutting carefully the ends?Picture 63.jpg
"Hi thanks for dropping the line. Well I have one more doubt. Can I make 10x4.7 prop to 8x4.7 prop by measuring and cutting carefully the ends?"
After the crash on yesterday I again rebuild the frame using new 12mm aluminium square pipe with same length of 14inch or 355mm with 10x4.7 props. Built the frame and mounted the motors and electronics. Reloaded the software with 4.5 + reboard…
"I think the earlier frame which I used and shown in the video is small (12in / 305mm) since the props size is 10x4.7 and there could be TURBULENCE building between the props causing the entire vehicle to imbalance and out of control. So I rebuild…"
"I think the earlier frame which I used and shown in the video is small (12in / 305mm) since the props size is 10x4.7 and there could be TURBULENCE building between the props causing the entire vehicle to imbalance and out of control. So I rebuild…"
"I've checked all the below and are correct.
- is the software configured for X and not + copter?
- is your "front" orientation correct on your board?
- is your board mounted right side up?
- do you have the CW and CCW props attached to the correct…"
- is the software configured for X and not + copter?
- is your "front" orientation correct on your board?
- is your board mounted right side up?
- do you have the CW and CCW props attached to the correct…"
"The props are 2 sets of CW and CCW of size 10x4.7 of APC composite propeller (LP10047)
Motors are 12 Amps 1450kv brushless outrunner (PowerHD)
12A BEC ESC (powerhd)"
Motors are 12 Amps 1450kv brushless outrunner (PowerHD)
12A BEC ESC (powerhd)"
