Gender
Male
About
Location
Brooklyn, NY
About Me:
Mech Engineer, design lover, Syracuse University, eager to learn more.
Please tell us a bit about your UAV interest
I'm very interested in developing and commercializing marine surface drones.
Hometown:
Hopkinton, MA
Activity Feed
"Gustav thanks so much for reply! I knew it was possible, but wasn't sure what I would be up against. Did you have to go through any special design setups/ major modifications to the tubes to make it work? Was water ever an issue with the tubes/…"
"Open to start discussing about both! Both are awesome and deserve a discussion"
Hey All, I'm looking to start some conversations about autonomous marine drones, especially ones that hydrofoil. If you're interested in joining the conversation, just jump on https://groups.google.com/d/forum/autonomous-marine-hydrofoiling-dr...
"Survmatic, thanks so much for the suggestion. As you can see above, I'm dealing with extremely heavy chop for the size of the boat, so I need a deep water solution as opposed to a hull bound solution. minimizing drag here is critical for the speeds…"
"Thanks for the suggestion Thomas, holding on to this as a fallback option, but I'm working with higher than average speeds where drag is a critical factor. The water wheel is an option, but won't work for the application. Lots of chop will prevent…"
"Working out ways to try to prevent that. Any ideas? Will water ingress up to the sensor if I I place it far above the tube? "
Hey All! I'm super new to the group, but I'm exploring low drag options to meausure speed through the water, not based on position. I was hoping to try to convert the airspeed pitot tube setup for use in the water. Has anyone had any experience…
