"Frsky S-Port telemetry stopped working for me.
I checked that it's not my cabling by reverting to master version from end of march, there it works again.
Did a ~15 min test today. No problems with any uncommanded pitch/roll, i can confirm that the…"

"MOT_PWM_TYPE=2: Pretty sure my escs support oneshot 125 (Dys SN 20A with BLHeli 14.4), didn't work on the quad though, props don't spin when armed, neither without nor with throttle.
Calibration doesn't work either, if i try calibrating when…"

"Same problem for me with px4, none of the standard frames worked at all, no possibility to put PID on poti, no autotune, what good is a firmware in which all things like rssi, FRSky telemetry etc work, but you can only be happy about these functions…"

"As written some time ago i didn't get rssi to work with the rssi-in pin of the pixracer. Neither with direct connection to Frsky Rx nor with normalized voltage.
Only way i got it working was by programming the Taranis to output rssi on channel 16…"

"Weird, for me it worked out of the box with x8r and x4r both using the sbus output and D16 mode.
Can you check the cable?
Does the Receiver turn on(leds)?"

"It's the same, just without the Teensy.
I.e. s-port out to FrSky in and sbus out to Rc in (like in the picture by Gervais).
After arming 12 new sensors were found by the Taranis.
With the stable version nothing was found."

"Never got Analog RSSI input working.
Installing latest dev version (2016-03-18 04:06) did the trick though, rssi over pwm is implemented there and it works out of the box (RSSI mode: 2, RSSI channel: 16, rx is x4r connected via sbus)
And not only…"

"Has anyone figured out how to read RSSI with FRSky Rx and Pixracer using Arducopter?
I tried connecting the RSSI out of the receiver directly to RSSI in of the Pixhawk. Regardless of wich Pin i configured, no value is shown.
I then tried again using…"

"The Values for ACSP4 are: 13.4545 Volt multi and 36.3636 Amps per Volt.
Calculated from Data posted at: https://github.com/PX4/Hardware/issues/53"