Gender
Male
About
Location
Orlando, FL
About Me:
I dabble in electronics, especially things like drones and love to see/play/fantasize about the latest and greatest gadgets.
Please tell us a bit about your UAV interest
My interests in UAVs is to make them better... of course!
Hometown:
Orlando
Activity Feed
I'm trying to use a DJI lightbridge with a Tarot 2D gimbal, come to find out the right angle HDMI jack does not work/fit. Anybody have any suggestions for alternatives? I was thinking of using a micro female to micro male, but I don't know if it…
"Nice Heli! What kind of flight times are you getting with this setup?"
"I know a lot of circuit designers place a resistor across the large capacitors to slowly reduce the voltage so there is not a large transient when things are connected or risk of someone getting shocked. I'm thinking this could also be a solution…"
"Thank you Thomas for the great info. "
"I did the same thing, but i put heat wrap around the three wires coming out of the motor.
When I attached the motor installed on the mounts. The top of the tubing was pressing hard
against the wire casings, and a couple of my wires split and the…"
When I attached the motor installed on the mounts. The top of the tubing was pressing hard
against the wire casings, and a couple of my wires split and the…"
"Anyone tried to run the motor wires through the mount plate holes with success? I see in the pictures you have them sideways to keep them from bending/fraying at the point of contact. "
"Job well done Trent!"
Testing the waters with higher capacity batteries and is wondering if any members might have experience with batteries found on the Chinese marketplace such as Yabo or gen ace knock-offs? I see that sites carry huge capacity batteries, such a…
