Gender
Male
About
Location
Bellevue, WA
About Me:
Started flying RC gliders in the mid 90's. Now I am interested in Gliders, Quads and UAV planes.
Please tell us a bit about your UAV interest
Learning to fly Quad and Airplane UAV's
Hometown:
Bellevue
Activity Feed
"I contacted 3dr and they said go ahead an do a factory reset. Because of the warning on the factory reset I contacted them first.
I think the instructions on the reset could be better. After the reset you also need to rebind the controler to Solo."
I think the instructions on the reset could be better. After the reset you also need to rebind the controler to Solo."
"I have seen backpack cases listed.
http://www.dronefly.com/product-p/bp11a.htm
I ordered one from dronefly ( although I have not received it yet, probably coming when the gimbal ships)"
http://www.dronefly.com/product-p/bp11a.htm
I ordered one from dronefly ( although I have not received it yet, probably coming when the gimbal ships)"
"The Pixhawk controller does not have a receiver. You need to connect your own. The Solo I believe is 2.4 ghz, but is using Wifi connection I believe, not a 2.4 ghz RC protocol receiver.
Not sure the Pixhawk will take a Wifi connection, but maybe…"
Not sure the Pixhawk will take a Wifi connection, but maybe…"
"fiberglass and expoxy"
"Oh I did look under the hood at the electronics. The GPS cables and they are plugged in okay"
Hello,I received my Solo the other day. Something I believe went wrong during the first time upgrade.My controller now shows the version on the controller as 1.0.5 and nothing on the Solo itself?Now it just sits for ever showing "Waiting for Solo"…
"It is a DC power supply for Turning 4 port charger. It can handle 4, 4 cell batteries. "
The solo batter uses an proprietary plug and charger. Does anybody know if 3DR will sell an adapter so I can charge 3 batteries at once with my RC chargers and Efuel DC power supply?Thanks
"Hi did your issue resolved? I have a QAV500 and Pixhawk controller. It was very unstable and I have not tried flying for a few months until I have seen if I can find more information."
Hello,I am having problems getting my pixhawk multicopter flying. It takes off and wobbles badly.I am using:QAV 500 framefpvmanuals 30 amp ESC with SimonK firmware Tiger Motor MT-4006-13 740kv graupner e propsI have checked the rotor directions…
"Did you get this working?
I have a pixhawk, X8R and MinimOSD as well and would like to see a setup help for this as well. "
I have a pixhawk, X8R and MinimOSD as well and would like to see a setup help for this as well. "
