Gender
Male
About
About Me:
making RC Hobby since more then 20years electronic studding some years but my problem stays software development
Please tell us a bit about your UAV interest
i own some Mikrokopters and now i like to join to Arudpilot controlled vehicles
Activity Feed
"i have used a Delta Mix Modul
at one Input from this Module comes Aileron Signal from the Ardupilot
and for Flap Mixing i have connect the Receiver out to the second Input from the DeltaMix
(the Deltsa Mix is normal used for Delta Planes, aileron…"
at one Input from this Module comes Aileron Signal from the Ardupilot
and for Flap Mixing i have connect the Receiver out to the second Input from the DeltaMix
(the Deltsa Mix is normal used for Delta Planes, aileron…"
"old shit with bad efficencty and much noise, bad control stability.
impellers are not a good choice for a hover platform
the Levitake.de Copter is more then 3years old
here has some one tried to make some tests with the chassis from levitake, but…"
impellers are not a good choice for a hover platform
the Levitake.de Copter is more then 3years old
here has some one tried to make some tests with the chassis from levitake, but…"
"i am here like a alone converser
but no problem you should hear about the bad boards
past a complete Reset from the EEProm and a new RC channel setup
it is working again
but only still RTL and no shitty way points
mode switch is correct
coordinates…"
but no problem you should hear about the bad boards
past a complete Reset from the EEProm and a new RC channel setup
it is working again
but only still RTL and no shitty way points
mode switch is correct
coordinates…"
"so past the first anger about the shit part
i am back from the airfield and have check the setup again
and it shows that this board has middle in use forgotten all his TX channel Setup, all channels was set to 1500, 1500, 1500
strange strange....…"
i am back from the airfield and have check the setup again
and it shows that this board has middle in use forgotten all his TX channel Setup, all channels was set to 1500, 1500, 1500
strange strange....…"
"hello there
first i have self the EM-406 and works only for RTL
then i changed to original MTK GPS and it lucks like i we have now the same problem -no stbilization and no servo out
http://diydrones.com/forum/topics/ardupilot-is-scrap
i try and…"
first i have self the EM-406 and works only for RTL
then i changed to original MTK GPS and it lucks like i we have now the same problem -no stbilization and no servo out
http://diydrones.com/forum/topics/ardupilot-is-scrap
i try and…"
slowly i like to put my Ardupilot into trash, real this unsolved problem here:http://diydrones.com/forum/topics/waypoints-not-working?commentId=7... between some of the new Firmwares along the last weeks, my last hope was…
"use the dip switch to reverse the direction and read the manuals for setup the board correct
"
"
Hello everybodyif i tell about not working wayoints, is there any step by step explanation for setup the Autopilot by newest Missionplaner and some hidden switches ?the MissionPlaner Wiki Page shows only CMD_Waypoint, what that meant CMD Waypoint…
