"When i use the Telem1.lua on my Taranis i get only a blank screen. 
Within the Companion Simulator everything looks fine.
Any ideas how i can working it on Taranis too ?

Do i have to remove the Scripts from the original Mavlink 2 FrSky Projekt…"

"Thanks for the fast reply.

I use the Timer 1 exactly with the same function in your script but realized that with a Logical Switch which gets the status from the APM.

When the Timer are fully conntrolled by the Script i will set both Timer in…"

"One question about the 2 Timer in your Script.

Do the Function "setTimer" overwrite the T1 and T2 Timer on the Taranis ?
Actually i set the 2 Timer in Companion with TH% and L8. Must i clear this values or on which value i have to set it ?…"

"Is that only relevant for Pixhawk Users ?

On APM 2.5 i can just update to rc10 ?

One unfortunate thing is that we found an issue with the Compass device ids and this will mean that a number of people need to go in and do their compass calibration…"

"I have actually one issue on my Telemetry Screen and have no idea what to do.
I have a 3d fix and on my Taranis i can see the correct Longitude but the Latitude is always 0°N 00' 0.0''

Is that a known issue an how can i fix it ?

Many thanks…"

"Thanks for the fast and clearly statement.
Then i need to connect my APM over a sbus2cppm converter.
I was just a little bit confused about the picture from this Thread on which it looks like it works without any converter.

Thanks
Christian"

"One short question about the Connection from the APM to the FrSky X8R.
On the picture there is a direct connection from the X8R to the APM 2.5 or 2.6.
I thought that ist not possible because X8R uses sbus and APM 2.5 only can PPM(CPPM)

Am i wrong…"

"Randy,
thanks for the fast reply.
I raised a new issue for that :-)

Battery Failsafe Issue"

"I have one question about the Battery Failsafe on APM 3.0.1

When a battery failsafe is triggered one of the following will happen:
Disarm motors – if you are in stabilize or acro mode and your throttle is zero
RTL – if you are in AUTO mode, have a…"

"Hi Reuben,

i checked your logs again and you are right. It seems that i checked the wrong file. It wasn't yours.
On the logfile from you i couldn't see a voltage. Do you use the 3dr Power Module ?

In the picture attached there are all motors and…"

"Hello Reuben,
my english isn't so good and i'm just beginning to understand the log Files.
I've attached a picture from your logfile at which you can see the Battery Voltage and the Altitude.
Do you use an 4s Lipo for your hexa ? In this case i…"