About

Gender

Male


Location

Mannheim, BW


Please tell us a bit about your UAV interest

Quadcopters


Hometown:

Mannheim


Activity Feed

Christian Winkler commented on Philip's blog post FPV setup with raspberry Pi
"Hi Patrick,
might be of interesst for you: We now have an Android App working.
As everyone has a smartphone nowadays, that is a cheap way to build some DIY fullHD Goggles.
http://www.rcgroups.com/forums/showthread.php?t=2281169
Kind regards Christian"
Nov 8, 2014
Christian Winkler commented on Pod's blog post Beginnings of Raspberry Pi FPV software
"I achieved this over Cable.
But for WiGi i use Ubiquiti Rockets M5, these add ~2-10ms to latency. No big deal."
Jun 29, 2014
Christian Winkler commented on Pod's blog post Beginnings of Raspberry Pi FPV software
"Same for me, tried to compile the 1.3.90 Gstreamer but got stuck. Takes forever on the Pi.
I am currently running on 1.2.4-1, these packages are available in the testing section of the official raspbian repro"
Jun 29, 2014
Christian Winkler commented on Pod's blog post Beginnings of Raspberry Pi FPV software
"You guys might be interessted of how to decrease Latency to ~110-130ms at least for 720p.
Do a
apt-get update
apt-get upgrade
The result is that we now have a set of mode as follows :

2592×1944 1-15fps, video or stills mode, Full sensor full FOV,…"
Jun 28, 2014
Christian Winkler commented on Philip's blog post FPV setup with raspberry Pi
"You guys might be interessted of how to decrease Latency to ~110-130ms at least for 720p.
Do a
apt-get update
apt-get upgrade
The result is that we now have a set of mode as follows :

2592×1944 1-15fps, video or stills mode, Full sensor full FOV,…"
Jun 28, 2014
Christian Winkler commented on Philip's blog post FPV setup with raspberry Pi
"Dear pod, could you share the link to the github page?
Actually i belive, the RPi should have enough performance to overlay some stuff on the stream, just looking at xbmc, wehere thet works."
May 4, 2014
Christian Winkler commented on Philip's blog post FPV setup with raspberry Pi
"Dear Pod, any news on the OSD front yet? I will try to set up suport for this project in the german fpv community forum. This could become a gamechanger for FPV. Just think of preconfigured RPi images for airborne and ground station, Hardware bundle…"
May 4, 2014
Christian Winkler commented on Rob_Lefebvre's blog post APM2 and Rx All-in-One!
"Steven, which SMD resistor is missing? This might be my problem on my APM2 as well."
Sep 8, 2012
Christian Winkler commented on Rob_Lefebvre's blog post APM2 and Rx All-in-One!
"@Jani, thanks, i love simple answers.
Even if i dont like the content ;-)
Looking forward to your solution, keep up your good work :-)"
Jul 8, 2012
Christian Winkler replied to Christian Winkler's discussion FrSky inverted TTL APM2
"Ok, now i ran into a problem it thought would not happen....
The CPPM Mode of neither D4R-II nor D8R-SP works with the Arducopter 2.6 Firmware on APM2....ARGH

Tried both variants:
1) Bridged signal input pins 2 + 3 and connected sum signal to…"
Jul 8, 2012
Christian Winkler posted a discussion
Hi together,i want to use a D4R-II together with APM2, PPM and RSSI are no problem. What i want to connect as well is the serial port of RX and APM2 to send compressed GPS information over the FrSky data downlink to my antenna tracker. in principle…
Jul 7, 2012
Christian Winkler commented on Rob_Lefebvre's blog post APM2 and Rx All-in-One!
"Hi together,

i want to use a D4R-II together with APM2, PPM and RSSI are no problem. What i want to connect as well is 
the serial port of RX and APM2 to send compressed GPS information over the FrSky data downlink to my antenna tracker. in…"
Jul 7, 2012