"Hey Ana Miarnau
I'm using Turnigy 9X Tr and Tx.
Got throttle failsafe to work with these #s Tx on 982, FS 915. Tx off 900, FS 915.
Had to Disable Fence to get motor arm. Steel no gps lock. Can't get help on what needs to be dun on the gps
lock. I…"
"Did the outside GPS test.
No GPS with Fence Enabled. Test time was 25 min.
Have to Disable Fence to arm.
Some are saying HDOP has to be about 250 or so for GPS to allow arming.
I don't know what or where HDOP is in Mission Planer. Can you tell me ?"
"Hi hector hind
Hop you can help. I cant get GPS lock with this.
APM Flight Controller Ublox NEO-6M High Precision GPS Module Built-in Compass
I have to disable the Geo Fence to Arm the Quad. I assume because I don't have GPS lock.
Can you give any…"
"Hi Mike
Still no Arming luck.
Mode: Stabilize
Here is my settings. Radio ON, Throttle value (Ch3) 982, FS 915
Radio OFF, Throttle value (Ch3) 900, FS 915
No GPS Fix, No PreArm messages come up on Flight Data Screen.
I sure feal lost. Must be…"
"I have been using the ArduCoper website. Some things work for me and some just confuse me.
Are the #'s that I posted for Radio 3 and FS good ?
Thanks again
Dale"
"Hi Mike
Thanks for responding.
Mod is Stabilize.
Tx on APM plugged in to computer. Looking at Initial Setup > failSafe. Radio 3 (THR) is 982, FS is 995
Tx off Radio 3 is 900, FS is 995
What do you think my settings should be if the Throttle cant go…"
Looks like most of the posting here is quit old. But here go's.When I try to Arm my Quad on Mission Planner, I get Check FS_THR_VALUSEand GPS: No Fix.Been searching for 2 days know. Can't find anything that helps.I hope someone can help me with this…