Gender
Male
About
About Me:
London-based techie with a drone obsession!
Please tell us a bit about your UAV interest
Building drones, flying drone, tweaking drone, filming (with) drones
Hometown:
London
Activity Feed
"My problem was solved by upgrading my power system to 6S. My hexa just needed some extra power. It now hovers at about 50% of maximum thrust, which is perfect.
If your hexa is wildly unstable then the first thing I would look at is your motor or…"
If your hexa is wildly unstable then the first thing I would look at is your motor or…"
Hi All ... My new build has been in the air now and I'm into tuning and log analysis. I'm hoping that Sunday will be windless enough for autotune. I checked for vibrations, GPS glitches, mag vs throttle etc. Most things look OK, but my DesPitch vs…
"OK. I have adjusted the logging to capture this on my next flight. I'll just get a bit up in the air and will aim to stick in stab mode.
If it is stable enough, I presume that I should get into alt hold and do an autotune."
If it is stable enough, I presume that I should get into alt hold and do an autotune."
"Thanks for the response. I do recall going into loiter at some point during the flight, so perhaps that's it.
The copter wasn't very stable in stabilise mode however, and still did wobble around.
Should I expect it to be OK on default settings…"
The copter wasn't very stable in stabilise mode however, and still did wobble around.
Should I expect it to be OK on default settings…"
Hi All!I'm hoping that someone can give me a quick tip on PID tuning on arducopter 3.1.5 ... I am fresh over from Naza land.I have built a hex with the following:Tarot t810 framePixhawk6x Tiger MN3508 380kv motorsTiger 15x5 props ublox compass +…
