Gender
Male
About
About Me:
Been into RC for years. Started with helicopters and have not stopped.
Please tell us a bit about your UAV interest
Video Piloting RC Heli's, Planes, Quads, Cars and Yachts. If it flies, floats or goes fast... chances are I probably have one.
Hometown:
The Land Down Under
Activity Feed
"Can you give an estimation of latency with the vivotech camera?
Maybe try shielding the cables, this may help with interference. Also could the camera itself could be producing some RF noise? (I'm not sure) I have heard of other HD camera's…"
Maybe try shielding the cables, this may help with interference. Also could the camera itself could be producing some RF noise? (I'm not sure) I have heard of other HD camera's…"
"Basically, I was talking about WHDI... <1ms latency. It makes use of OFDM transmission. It's one of the consumer wireless hdmi technologies. Prices are around $300 from what I've seen. Much less than the $20,000 Pro level COFDM HD transmitters.
I'll…"
I'll…"
"Oops. I meant to edit my post... not delete it"
"FTDI Cable should be just fine, although make sure your BT Board is compatible with the output voltage and the logic level of your cable (my FTDI cable, provides a 5V supply with 3.3V logic levels). With my JY-MCU BT_Board (V1.04 3.3-6v) I did not…"
"Graham, this web page may help, it has heaps of good info on configuring these BT devices. http://wiki.openpilot.org/display/Doc/Serial+Bluetooth+Telemetry
Basically you need a rs323 to ttl converter of some description. Personally, I used a Arduino…"
Basically you need a rs323 to ttl converter of some description. Personally, I used a Arduino…"
"Hi Kevin, Good News! It's working! Thank you! I unpaired all the (many) devices in my phone and paired my BT module again. After that it's now working.
Thanks heaps!"
Thanks heaps!"
"I am trying to connect APM2.5 + Bluetooth to my Android device (Xperia S). I have followed the directions, but no connection is established. Andropilot just says "Please connect telemetry". I have a working Bluetooth connection to my PC but…"
