Hello all,I was thinking about the conversion of my old ArduPilot Mega 1280 + Oilspan into a digital level tool.I need to attach an LCD display: as you know the Arduino LCD library requires 6 digital pins. I was wondering if it's possible to use the…
"I've got it, and it is working fine, but i would like to connect the shield to a standard mega board, like this one.
I've been able to use the pressure/temperature sensor (the BMP085), but i'm having some difficult to read the ADC ADS7844 (where the…"
Hi all,i have an old APM IMU shield. I was thinking if it's possible to reuse it in some other project, especially for the nice gyro/accel and pressure sensors.My idea was to interface the shield with a new Arduino Mega 2560 Board, so i can easily…
Hi all, i need help here.i've just downloaded the APM code v1.0, and i've followed the tutorial to set up the Arduino IDE and load the APM code; i've uncommented the GPS_PROTOCOL line and i've set it up to GPS_PROTOCOL_NONE. Then i launch the…
This morning i decided to buy the APM + OilSpan but unfortunately the OilSpan and the 3x8 Right Angle Pin Headers are out of stock. :(Any idea about when these will be aviable again?I also noticed that ArduPilot Mega is aviable only at SparkFun...…
Hi all!Basically, these are "The Questions" of every newbie like me.1 - I'm trying to figure out the relation between the maximun weigth (comprising payload) of a quadcopter and the motors required.Somewhere (can't remember where) i found that, to…