Gender
Male
About
Please tell us a bit about your UAV interest
freedom
Activity Feed
"There is no enough power from usb to give addition power to i2c device, i2c device should have separate power source."
"I have the same issue, connect with futaba 6203sb. In qgc, rc signal cal. Normal, everything normal, however, after push safety button and arm stick position, lights ready, the motor no reaction with the throttle. Then i flash back to apm firmware,…"
"I just received the pixhawk, and i am facing the same problem of getting connect with Futaba sbus receiver 7008sb, 6203sb, ... there is no any value output at MP. All same as subject described."
"i didnt find the name of "sonar" status meter reading or graphic this? anyone can advise me, thank you."
"why the video so secret unlisted at youtube! Very hard to find."
"Any users video uploaded for enjoy?"
"i have the same problem with you. I m using MB1260, when i switched to alt hold, the quad raise continuously. I will going to buy 10k resistor, 1500uf 6.5v cap and shield 3pin cable to replace it. Let see did it improve!"
"Hello
I have ublox6m, i can successfully change the baud rate to 38400, but still have error when upload the configuration file. Any guys can success to config Ublox6m used with apm2?"
I have ublox6m, i can successfully change the baud rate to 38400, but still have error when upload the configuration file. Any guys can success to config Ublox6m used with apm2?"
