Gender
Male
About
Location
Antofagasta
Please tell us a bit about your UAV interest
Photography, video and hobby
Hometown:
Arica
Activity Feed
"Hi, the Pixhawk was located between the plates of a DJI f450 frame (over the power distribution board) also i tried with the FC over the frame but the problem never gone. I sent an email to 3dr support with logs, because i thought that my Pixhawk…"
"Hi,
I think that i have the same issue, occasionally when i change the battery the quad flies, but its impossible to make a second flight and sometimes when the drone flies normal after some time flying the speed of one or two motors decreases and…"
I think that i have the same issue, occasionally when i change the battery the quad flies, but its impossible to make a second flight and sometimes when the drone flies normal after some time flying the speed of one or two motors decreases and…"
"Hi, Im not sure if my pixhawk has this problem;
I have an original 3DR Pixhawk with the DJI e300 kit and the drone only flew well few times, before with AC 3.2 i got a lot of prearm warnings, althought with AC 3.2.1 the number of warnings got…"
I have an original 3DR Pixhawk with the DJI e300 kit and the drone only flew well few times, before with AC 3.2 i got a lot of prearm warnings, althought with AC 3.2.1 the number of warnings got…"
Hi, im a newbie on drones and after some research in the area i decided to build a quad based on pixhawk(original) + GPS(from 3drobotics) and the Dji e300 kit on a f450 frame with a Turnigy 9x RC using a ppm encoder (from 3drobotics) After the setup…
