your suggestions were exactly what i tried before. I will try this tonight with an X8R at home and see if it works - if it does, then it's the X4R, if it doesn't, then it is my compilation etc.
In case it is the X4R, i could send you one…"
"No problem - i just thought it would be funny - maybe it was just too much - in the end it's all about making things work here to my knowledge - all fine from my side.
Maybe i should also try to burn the hex files for my case. For me it looks like…"
i still have issues getting this to work with the X4R receiver which is much smaller than the X8R (my models partially do not have space for the X8R) - the issue is here that the receiver itself internally uses A2 which causes a conflict.…"
sorry for asking again - has anyone tried this code with the X4R receiver ? Unfortunately, i can not figure out what to change to make it work. I would be very happy if someone could give me a hint.
"My pleasure - you are welcome. I was just trying to help you - in fact, the web-site linked seems to answer most of the questions except the one "has someone tried this" -but assuming the manual has been written with some testing, i would expect it…"
in the hope that someone helps me with my problem above, i try to help you a bit.
Basically, you need e.g. Arduino 1.0.6 (you can download the non-installation version if you are using a newer arduino software for something else). - In…"
I am trying to use this togehter with the X4R-SB (which i use with a SBUS to PPM adapter) as i can not fit an X8R in my craft.
Unfortunately, i get really fluctuating values on A2 (the X4R already has an analog interface for the A2-Value…"
"Hi !Just for Info: In case you upgrade the firmware and use Telemetry, you will likely end up with a broken mavlink connection "No heartbeat received" -
The problem is that the original APM firmware of the cheerson was modified and they use RX2/TX2…"
Hello Everyone,i am trying to get Telemetry to work on Port RXD2 / TXD2 - (Atmega Pin 12 / 13) for Telemetry and Mavlink instead of RXD0/TXD0.Unfortunately, for several reasons, i can not use the default telemetry port and really need to use Pin…
ich habe den Copter mal ungefähr mit ECALC durchgerechnet - mein erster Eindruck war: Viel zu viel Leistung bzw. KV für das Gewicht - aber interessanterweise ist dem scheinbar doch nicht so. Es fehlen aber ein paar Angaben: Genauer…"
I can share your frustration. After a software bug leading me to go to the hospital and getting my arm put together again, after many many crashes etc. i went away from arducopter. - Up to now, i did not regret it. - I switched to the "three…"
den Zusammenhang mit der Software kann ich nun nicht herstellen - ich hatte allerdings in der Vergangenheit das Problem, dass bei hohem Stromfluss das Magnetfeld der Leitungen den Kompass beeinträchtigt hat. - Kann es evtl. daran…"
Hello Everyone,after having bothered the forum for quite a bit and quite some issues setting the copter up (took months, before it worked), many many crashes and broken equipment, i got one arducopter flying. - Unfortunately not for long as it…