Gender
Male
About
Location
Atasehir
About Me:
I am a software engineer and live in Turkey.
Please tell us a bit about your UAV interest
High Motivated...
Hometown:
Istanbul
Activity Feed
"Hi,
I think i solved the problem.
I change THR_MIN value to 150 and RC_SPEED value to 100.
I found this solution while searching in forums.
Maybe THR_MIN change could be enough.
I tested this at ground level.
I will fly as soon as possible and We…"
I think i solved the problem.
I change THR_MIN value to 150 and RC_SPEED value to 100.
I found this solution while searching in forums.
Maybe THR_MIN change could be enough.
I tested this at ground level.
I will fly as soon as possible and We…"
Hi All,First of all My escs and radio were calibrated.At startup randomly one motor does not start after about 3-4 three minutes successfull run.If motor starts there is no problem it continues to start and spin.On my video look at startup, 2.07 and…
Hi All,I am disarming after 3 minutes run at ground and motors are getting little hard to spin by hand. I think it is normal. Am I right?I am rearming after about 2 or 3 seconds and sometimes randomly one motor is not spinning. If I give a little…
"Thanks Again.
I am learning a lot of things.
Battery Fail Safe voltage was 22.4 Volt. Last seen voltage value is 21.x volt.
Could It be activated?If It was actviated Could We see it at logs?
It is seen a connection problem I think.
Stupied me :)
"
I am learning a lot of things.
Battery Fail Safe voltage was 22.4 Volt. Last seen voltage value is 21.x volt.
Could It be activated?If It was actviated Could We see it at logs?
It is seen a connection problem I think.
Stupied me :)
"
"Hi,
It could be voltage sag problem?
Best Regards."
It could be voltage sag problem?
Best Regards."
"Thanks Andre,
I am using standart 6-pos DF13 cable with Dshot® Power Module because it supports 6S battery.
No power applied to USB or Servo rail. No extra power.
Is it normal last logged 21.71 Volt battery voltage?
Because I measured battery and…"
I am using standart 6-pos DF13 cable with Dshot® Power Module because it supports 6S battery.
No power applied to USB or Servo rail. No extra power.
Is it normal last logged 21.71 Volt battery voltage?
Because I measured battery and…"
Hi All,My quadcopter suddenly fall down after 50 seconds.Before the fall I flew 3 minutes successfully at Alt Hold mode.After crash I measured battery and it showed 23.74V but at flight log CURRENT:Volt value is 21.71Volt at last log row. Before the…
"Please Help..."
Hi,My home made quadcopter suddenly fell down after 50 seconds at second fly.Before the fall I flew 3 minutes successfully at Alt Hold mode.After crash I measured battery and it showed 23.74V but at flight log CURRENT:Volt value is 21.71Volt at last…
