Gender
Male
About
Location
Terengganu
About Me:
Student From malaysia
Please tell us a bit about your UAV interest
developing autonomous arduboat
Hometown:
Terengganu, Malaysia
Activity Feed
"Hi Grant,
Thank for reply, i try to change the tuning and nothing happen, when the boat start in auto mode the servo automatically turn to the right. I will upload the video later.
Thanks."
Thank for reply, i try to change the tuning and nothing happen, when the boat start in auto mode the servo automatically turn to the right. I will upload the video later.
Thanks."
"My boat are normal in manual mode, the weight is balance, but the speed in auto mode I don't know how to adjust it to make it slower"
Hi,I am using RC tugboat and i have issue where my boat does not follow the waypoint set up and if turn to auto mode the boat will move in zig zag position.here are the details of hardware i used :APM2.6 ArduPilot Mega 2.6 External CompassAPM Flight…
"Grant, i have corrected the cable for input and output. Now the Radio is calibrated. I have upload the photo that have been correct. The problem occur now is the motor and rudder are not moving after the way point is set up
Thank, Harris."
Thank, Harris."
""
"David, the boat are not arming itself.
Actually i did not quite understand how to powering the servo rails for outputs.
For APM, i am powering it with power bank."
Actually i did not quite understand how to powering the servo rails for outputs.
For APM, i am powering it with power bank."
"Thank You Tom, Grant and David, you guys are help full.
I have problem where the motors and rudder are not moving. "
I have problem where the motors and rudder are not moving. "
"Hi, i would to ask your opinion if i am using Futaba 8J 2.4GHz S-FHSS 8-Channel Radio System is it, compatible with the ardupilot.
Thanks"
Thanks"
"Thank you for your reply,
yes correct it only has two channel, means i have to change the receiver into APM input? I have a wrong schematic sketch then. I will try to change it. Did u have any suggestion for trasmitter and receiver model that are…"
yes correct it only has two channel, means i have to change the receiver into APM input? I have a wrong schematic sketch then. I will try to change it. Did u have any suggestion for trasmitter and receiver model that are…"
Hi, i am working on arduboat using Traxxas Villain Autonomous R/C Racing Boat. The problem i am having is the calibration radio is not working and the green indicator are not moving at all.here are the details of hardware i used :APM2.6 ArduPilot…
