About

Gender

Male


Location

Auckland


About Me:

Mechatronics Engineering Student


Please tell us a bit about your UAV interest

Focus on Quadcopters using APM and Rovers


Hometown:

Auckland


Activity Feed

J_Pat posted a discussion
Hi Guys, I am trying to get a LV-MaxSonar EZ0 MB1000 Sonar module working with a Pixhawk. I have connected the sonar using the 3 wires according to the ArduCopter documentation to the 5 pin ADC port. I have the ticking noise coming from the sensor…
Oct 1, 2017
J_Pat posted a discussion
Hi Guys,I have been trying to set up a FPV system. I've managed to wire it all up to make sure all components are receiving their correct voltages. I seem to be only receiving a really fuzzy image on my screen through and i cannot work out why.My…
Sep 15, 2016
J_Pat posted a discussion
Hi guys, i am looking at a new radio com system for my new quad build. I was wondering if it is possible to connect a DragonLink V3 transmitter to Mission Planner for the telemetry option, and then be able to use the Joystick control that Mission…
Jun 22, 2016
J_Pat posted a discussion
Hi guys, just wondering if anyone has any views on the Pixhack and Pixhawk. Looking at getting one and am not sure which one is better and what advantages each one presents. Any suggestions??
Jun 21, 2016
J_Pat posted a discussion
Hi guys, was just wondering if any of you know of any good systems or set ups that can provide a long range telemetry link through mission planner and one i can connect to my computer. This is to replace the current 915 Mhz 3DR mavlink system I am…
Jun 16, 2016
J_Pat replied to J_Pat's discussion M8N GPS, APM 2.8 Accuracy and Land mode issue
"Thanks for that. Will look into making one. Could my geographical location be playing a part in the number of satellites i pick up as I i am down in New Zealand?"
Jun 14, 2016
J_Pat replied to J_Pat's discussion M8N GPS, APM 2.8 Accuracy and Land mode issue
"There is the module above, it doesn't look to be the one that you described. The gps is positioned above the controller by about 15 cm. It is away from all the ESC's but reasonably close to the telemetry transmitter   "
Jun 14, 2016
J_Pat replied to J_Pat's discussion M8N GPS, APM 2.8 Accuracy and Land mode issue
""
Jun 14, 2016
J_Pat posted a discussion
With regards to a M8N GPS connected to a APM 2.8, is it normal for it to be wildly moving around while the Quad is stationary on the ground? On Mission planner it shows the Quad moving all over the place, around +- 20 meters to where it is situated.…
Jun 14, 2016