About

Gender

Male


About Me:

I love RC models for years. Can do thing or two with computers, love golf and skiing.


Please tell us a bit about your UAV interest

Small quad, then bigger one and now hexa with gimbal for GoPro. I just got infected with this..


Hometown:

Prague


Activity Feed

Jakub replied to Jakub's discussion When moving in AltHold or Loiter copter shoots up - looking for advice
"Just short update from me -- I solved the issue finally by switching to 32bit platform and also by mounting the flight controller on a dumping platform. With these two combined I probably do not reach the clipping and everything is solid. Thanks a…"
Nov 30, 2015
Jakub commented on Chris Anderson's blog post The long road to a robot dragonfly
"This is a big disappointment for me. Unfortunately."
Apr 11, 2015
Jakub replied to Randy's discussion AC-3.1 autotune support discussion
"After few more attempts I had finally somewhat succeeded. I did two changes at once, so not really sure which one helped more. At first switched from 'X' frame configuration to 'V'. And then also put more weight on the copter - 3300mAh 3S battery…"
Jun 22, 2014
Jakub replied to Randy's discussion AC-3.1 autotune support discussion
"Good evening to all autotuners,
trying to tune mini spider hex from Blackout. Flies OK just as it is but when I invoke autotune it finishes itself too early. It just never starts fliping from front to back. I have done many attempts also with…"
Jun 17, 2014
Jakub replied to Oliver Volkmann's discussion FW3.1.3 - Switch to Loiter = CRASH! in ArduCopter User Group
"GPS was malfunctioning at the end of your flight. Number of satellites went from 11 (which is quite a good number) down to 10 (which should be also good enough number but apparently wasn't) and shortly after that error state followed. So I assume…"
Apr 26, 2014
Jakub replied to Randy's discussion AC-3.1 autotune support discussion
"Another autotune attempt, this time on a hexa Tarot 680. After parking for a while in AltHold the process started. Took around 3 mins then stopped again. Initial PIDs were not optimal so that's why you can see in the log files how hexa ascends up to…"
Dec 4, 2013
Jakub replied to Randy's discussion AC-3.1 autotune support discussion
"Just wanted to add my very good experience with autotune. I had run it for 3-4 times already and the results are very good. Copter is absolutery steady with the recommended PIDs. I will check how it behaves when Stabilize P are a bit lower than…"
Dec 3, 2013
Jakub replied to Jakub's discussion When moving in AltHold or Loiter copter shoots up - looking for advice
"After adjusting THR_MID to 405 as suggested by Tom, I flew the copter again. It seemed that it's slightly more difficult to get it to that state. But after few attempts it was there again. Especially at the times 2:55 and 4:20 in the video from last…"
Nov 26, 2013
Jakub posted photos
Nov 24, 2013
Jakub posted a discussion
I'm looking for an advice what should be tuned differently in my otherwise very nicely flying copter. It's very stable, vibrations are well within recommended limits - when recording video with GoPro there is no jello at all. However when I switch…
Nov 22, 2013