Gender
Male
About
Location
Trumbull, CT
About Me:
Flying 3D helis for 2 years, been flying my two quads for about one year.
Please tell us a bit about your UAV interest
Interested in UAV, I have spent a few years learning to fly first, now I am ready to get into UAV's. And a little AP.
Hometown:
Connecticut,USA
Activity Feed
"Not compatible , the wiki is correct.
2-3 months for what unit to arrive? I do not follow your post. Let us know what unit you are referring too and we can direct you where to purchase. There are hundreds of GPS/ Compass modules Pixhawk compatible…"
2-3 months for what unit to arrive? I do not follow your post. Let us know what unit you are referring too and we can direct you where to purchase. There are hundreds of GPS/ Compass modules Pixhawk compatible…"
Hello, I have my Lidar lite hooked up PWM to my plane (using Pixhawk). Small issue, getting readings but at its lowest point, when belly of plane is on ground (I have Lidar mounted under wing), it should read about .1 meters, thats 1/10 of a…
"I also am having this problem that you have now corrected. I am flying a Hercules wing on 4S, twin engine. The last two flights when I enabled RTL my plane ended up in a steep dive, both times I regained control. I am using the new digital airspeed…"
"Tridge, when I upgrade to 3.1.1 on my flying wing, do I need to re-do the accelerometer calibration? Thanks Jeff"
"Randy
I still have 3.2RC1 on two of my Quads from when I downloaded during the short time it was available. Besides the normal bets risks, any reason why I can't continue testing?
Thanks JEFF"
I still have 3.2RC1 on two of my Quads from when I downloaded during the short time it was available. Besides the normal bets risks, any reason why I can't continue testing?
Thanks JEFF"
"I hard mount my Pixhawk
You shouldn't need to do all the vibration dampening. A Beastx from a programming perspective is NOT comparable. It is so different I cannot even begin to write the differences ."
You shouldn't need to do all the vibration dampening. A Beastx from a programming perspective is NOT comparable. It is so different I cannot even begin to write the differences ."
"+1"
"Most standard quads will fly with the default PID's
I have set up numerous vehicles with APM/PIXHAWK
I can achieve a Loiter better then DJI A2
And PIXHAWK $200USD, DJI. $1100 plus
Read the Wiki, if there is a mechanical issue including vibration it…"
I have set up numerous vehicles with APM/PIXHAWK
I can achieve a Loiter better then DJI A2
And PIXHAWK $200USD, DJI. $1100 plus
Read the Wiki, if there is a mechanical issue including vibration it…"
"Just curious
I looked at your header on the upload
Flight time 6 minutes, at 1300 meters
Is your quad in visual sigt at 1300meters?
I have flown over water at 1000 Meters but at 38 minutes time
What is your clime rate in m/s"
I looked at your header on the upload
Flight time 6 minutes, at 1300 meters
Is your quad in visual sigt at 1300meters?
I have flown over water at 1000 Meters but at 38 minutes time
What is your clime rate in m/s"
"The second your quad started to appear to be flying off you had plenty of time to switch to MANUAL mode, fly back and land safely
Learn how to fly before using any auto command
Best of luck"
Learn how to fly before using any auto command
Best of luck"
"Have you checked output pins 1-4 to ensure they are producing a signal ?
I have done the all in one on all my copters with 3 different brand of ESC
Works every time
What brand of ESC are you using ?"
I have done the all in one on all my copters with 3 different brand of ESC
Works every time
What brand of ESC are you using ?"
"I don't believe either of those are the defaults"
"Are your ESC's calibrated? What number do you have motor spin armed set at?"
"Are you flying your vehicle in a populated area ?
What is your RC experience ? What is a MAJA drone?
I am not familiar with that model?"
What is your RC experience ? What is a MAJA drone?
I am not familiar with that model?"
