Gender
Male
About
Location
Plzen
Please tell us a bit about your UAV interest
I`m interesting in autonomy rovers, ballancing scooters and unicycles
Hometown:
Plzen
Activity Feed
"I am sorry, but i did nit find this parameter in full parameter list. What i doingwrong ? APM firmware ver 2.45.
Thanks for help
Josef"
Thanks for help
Josef"
"Thanks a lot. Are any other specialities for skid steering ? Tomorrow i will test it. "
"There is full video H.A.L. Hexacopter with external compass and GPS antenna modification
We tested Stabilize, AltHold, Loiter, RTL and Auto Mode
"
We tested Stabilize, AltHold, Loiter, RTL and Auto Mode
"
"After modification i had to install new firmware because I used this APM for ardurover. And after install new firmware i had to make all calibrations. But i think that compass and GPS interference was main problem. And in first flight a made auto…"
"Exactly. After two circles crash"
Two weeks ago i crashed with my hexacopter with APM 2.5 and uBlox LEA 6-H GPS. In loiter mode drone behaved unpredictably. According to symptoms, it was probably about a compass interference. I use my older APM modified to external compass and use…
"Thanks. After testing let you kow.
Josef"
Josef"
"Richard, thanks a lot for your reply. I choose another solution. I ordered 4s batteries instead of 3s what i use now. I think that will be better for throttle range. Maybe. What you think about it? When i tested althold mode hexacopter slowly climb…"
Today I make first flying test on HAL hexacopter. In stabilize mode everything is OK but ALThold and loiter mode dont work. I analyzed telemetry log and throttle is average on 70 %. It can be reason ? I have two 3s 4000mAh and NTM 2836 750 KV…
"I dont know solution, but i have same problem on my notebook. I think that is too many com ports problem. I have big numbers of com ports too. When i used netbook of my childrens everything was OK.
So when i need upload new firmware take childrens…"
So when i need upload new firmware take childrens…"
On this video in some parts of driving my rover oscillates. But only in some parts. Firmware is 2.42. It may be due to the PID parameters?ThanksJosef
"In my rover its same
Josef"
Josef"
